3600a manual

DSI claims that there are virtually no spurious emissions from the case, and I corroborated that using my old standby Millen gdo as an absorption wavemeter Nothing could be detected on the Millen from the BC band through the highest frequency of the gdo. Score one for DSL. The front of the counter is a transparent dark red pane!

Along with the 8-digit display for frequency readout there are two other LEDs. One indicates gating time, while the other monitors the cycling of the crystal oven The base frequency oscillator is temperature-compen sated using the time-proven crystal oven technique, and!

Score another one for DSI. There is but one control on the counter, and that is its "gating switch," which selects one of two timebases in either the direct or prescaled ranges The rear of the unit has three connectors A mini phone jack serves as power input, and two SO UHF connectors are used for both rf inputs.

To check a frequency counter, one needs a source of signals to read, as Well as something to compare against. Well, what can the "average" amateur use as a standard of comparison? In my case, 1 happened to have tweaked my Clegg FM MHz radio earlier in the week on a multi-kilobuck counting device. Some manuals combine types i. Please see availability below. Shop manual or Repair manual tells you how to take the International Harvester Industrial Tractor apart, fix it, and put it back together.

Choose Model Choose Model. Search Reset Menus. Add to Cart. Qty Add to Cart. This option offered by Kurt Manufacturing Company is ideal for that. The O-Ring installation will provide for the movement needed when working with parallels. Improper maintenance will result in poor vise performance and may void your warranty.

Remove chips from surface of vise. Tighten the setscrew to firmly contact the nut. The movable jaw is designed to move slightly pivot side to side so maximum jaw plate contact is maintained when clamping out- of-parallel, sawed, or cast parts. Clean and inspect the counter bore, thrust washers and thrust bearing. Apply water resistant grease to the thrust washer i.

Install thrust bearing assembly on the screw in the reverse manner.