Seat jack installation instructions

Remove the plastic wing nut from the current plastic jack cover, behind the seat. Best selection, lowest prices, plus orders over ship free. We Ship Today! Tilt and slide the seat forward. Behind the seat you will have a jack tools bag. Turn the plastic wing nut Read and understand all instructions and warnings prior to installation of product Always wear your seat belt. Install the Wheel end bearing and seal installation guide.

Installation Instructions Cont. Shop with confidence. Seat Belt Installation. Outfit, repair, and. The aspect of the seat and the quality of the components are excellent. What is great about the seat is that if you want to go for a solo ride it only takes a few minutes to take it off. An amateur mechanic can easily install the seat without any problem. Skip to content How to install the Kimpex Seat Jack, step by step. Hugo Lorquet October 17, am Articles.

The seat The first step is to set the two side plates on each side of the seat. Template Template on the platform Before you do the drill, you have to install on each side of your snowmobile the inside bracket. Bracket modification Bracket UnI used a punch to be sure that the holes were well centered.

Hugo Lorquet. Follow us. Facebook Twitter Youtube. Latest publications My predictions for Polaris! The base and backrest of the seat are well padded and their shape allows the passenger to remain steady. With the particular design of the Seat Jack, the passenger sits totally on it without taking up the space of the snowmobile seat.

This way, the pilot keeps all his seat. The built-in handles are equipped with deflectors to protect hands against wind and bad weather. Also, a version of the Seat Jack is offered with heated grips and heated visor outlet. On this edition, the passenger controls the heat of his handles. The assembly kit or knob has also been redesigned so that it would not alterate the look of the snowmobile when you remove the seat.

Effectively, the old rails have been replaced by 4 small knobs that most of the people will not even see. You can take the seat on and off in less than 10 seconds. The instruction sheet provides detailed mounting procedure. You will have to drill 4 small holes to install the knobs.

Also, on the version with heated grips and heated visor outlet, you will have to connect a wire to the electrical circuit of the snowmobile. And that's it! The seat we had for this trial was the model with heated grips. He had plenty of space to be comfortable when we were riding on trails. The heated grips were very effective.