Well yeah, I went through every beta build on the site systematically at one point and didn't have it running even with and the older when I tried them the first time, which made me think it was some other issue. Not brave enough yet to try anything newer than tho, happy that it's working in it's current form. Posted: Thu May 10, Post subject:.
Does this also apply to my wrt54GL's?? If not what is the newest build that can be used? And does that build get the K2 patches etc covered? Posted: Fri May 11, Post subject:. Sam wrote:. Hadn't recognized the nomenclature your sig uses to show which build for each router. How do you like your Rv2's? This would seem to make the build r almost my "go to" build for all my routers except for the wrt I wish I had two Rv2's instead of the 2 E's I just have a Rv1 non-ARM.
There have been several in the past months; and I think something was recently fixed in post builds; may only affect k4. Earn Credits. Step 2: Do a hard reset on the router. Step 3: Set a static IP address on your computer. Set static IP address on your computer to Subnet mask should be Step 4: Connect your router to your computer.
Step 5: Power cycle the router. Unplug the power cord from your router for 30 seconds then plug it back in. Step 6: Log into your routers GUI. Step 7: Go to administration and firmware upgrade. Step 8: Brouse to the bin file of the new firmware. Step Power cycle the router.
Step Another Hard Reset. Step Reset your computer ethernet connection. Log in Profile View unanswered posts Log in Username:. View previous topic :: View next topic. Ok so I know you experts keep speaking of reflashing with JTag blah blah blah and I know there is the wholeflash. I want to reflash my unit with the wholeflash so that dd-wrt no longer exists on it.
Back to top. Posted: Tue Feb 24, Post subject:. My WRT54G2 works fine after return! Linksys firmware 1.
0コメント